Ayvaz separator is a device that separates the liquid transported by steam, gas and compressed air in the installation by centrifugal force and makes it dry and clean.
AYVAZ SPR 16, 25, 40 Separators are specially designed to maintain high efficiency, variable steam rates and separation efficiency in lines running up to 16, 25, 40 bar. This product can be specially produced from stainless steel for process systems.
Working Principle
It is not possible to distribute liquid droplets regularly across the entire pipe cross section. It is easy to take the liquid that flows from the bottom of the pipe. Those who move freely can only be collected by separators. When the free state and variable size moistred gases enter the seperator, the centrifugal movement begins around conical cyclone downward, and the liquid particles, droplets and sediments in the acclerated gas are swirled away from the wall.
The dry, clean gas with large internal volume goes to the collector conical cyclone, optionally through filtration, and continues to the installation path. The liquid and sediments descend into the collecting chamber below the separating stainless plate, and can not go up. The fluid moves through the filter and it can be drained by steam trap or by hand. The level of the liquid in the collector can be controlled by the control pipe.
Seperator Selection and Efficiency
Ayvaz separators operate at wide speed range, which improves system efficiency.In general, the connection is selected based on the pipe diameter. But in real sense, it is necessary to determine the separator diameter according to the selection input pressure and the flow rate. 99% of the water droplets over 10 microns disintegrate the entire solid particles. The pressure loss in such separators is less than 0.95%.
Pressurised Air Applications
The air that the compressor absorbs with dust and various particles is compressed by the burnt oil from the compressor. If the water, oil and residue can not be seperate, it could spread all the line .
The Ayvaz Seperator to be used at the compressor outlet separates 99% of the water particles and all the solid particles from the air. When high precision air is required, dryers and filters should be used.